Skip to main content
A transition blends the cut between two clips instead of switching on a single frame. In Studio, transitions belong to the cut itself: they run across the boundary where one clip ends and the next begins on the same track.

​
Available transitions

Cross Dissolve is the default and the safest choice — dips read as deliberate chapter breaks, and wipes carry a stronger stylistic flavor.

​
Placement

Transitions work between adjacent clips on the same track. Each one is anchored to the cut: half of its duration plays over the end of the outgoing clip, half over the start of the incoming clip. That means both clips need a little material on either side of the cut — if a clip runs out of frames, Flowy blends with whatever is available. A transition rides with its clip. Moving the clip moves the transition with it, and duplicating a clip (⌘ J) copies its transitions too.

​
Duration

Transitions default to 0.5 seconds — long enough to register, short enough not to drag. Shorter durations tighten the cut toward a subtle blend; longer ones slow the pacing and draw attention to the change.
Transitions render across the cut in the preview and in your exported video alike — scrub the playhead slowly across a cut to inspect the blend frame by frame.